New guidance covers draft, wall thickness, parting line placement and the tolerance threshold that turns an as-cast part into a machined one
COLUMBUS, Ohio, Nov. 19, 2026 /PRNewswire/ -- MES, Inc., a global manufacturing sourcing and supply chain company serving Fortune 500 OEMs, today released design guidance for die cast electrical enclosures, mechanism housings and switchgear hardware. The guidance shows that the biggest cost and quality drivers on a cast enclosure are set on the drawing before a tool is cut. The main ones are draft, wall thickness and tolerance.
The timing matters for electrical OEMs. Data center construction is expected to triple the U.S. power equipment market to $65 billion. Medium-voltage switchgear lead times now run 52 to 80 weeks, up from about 24 weeks historically. With schedules that tight, a casting that needs a drawing revision after first articles costs time nobody has.
"Most of the enclosure drawings we review were designed as if the part would be machined from solid stock," said Hiten Shah, President and CEO of MES. "We see square corners, no draft, a thick boss added for strength and one tolerance block across the whole part. None of that is the caster's fault, but the buyer pays for it on every part for the life of the program."
Five design rules from the guidance:
- Draft is required, and it isn't uniform. Two degrees is a reasonable default on an external aluminum wall. Deep pockets, long cores, textured surfaces and inside walls need more. Short polished walls can go as low as about half a degree. Zero draft can't be made.
- Thick sections don't add strength. Aluminum solidifies from the die wall inward, so the heaviest section freezes last and collects shrinkage porosity. For A380, a 2 to 3 mm nominal wall is comfortable, 1.5 mm is achievable on a good flow path, and anything above about 5 mm should be justified.
- Stiffness comes from ribs. A 2.5 mm wall with ribs at about 60 percent of wall thickness is stiffer, lighter, cheaper and sounder than a 5 mm wall with none.
- Keep critical dimensions in one die half. A dimension that crosses the parting line picks up die closure tolerance on top of everything else.
- Review tolerances one by one. There's a grade the process holds as-cast and a grade that needs secondary machining. On paper, you can't see where one ends and the other begins.
"Tolerance cost doesn't rise gradually. It jumps," said Brad Layne, Engineering Manager at MES. "Go one grade tighter than the process holds and you've added a second setup, a fixture and a per-part machining cost. Usually only a few dimensions need that control, like mounting interfaces, sealing surfaces and bearing bores. A uniform tolerance block means paying for the tightest one everywhere."
MES die casts aluminum and zinc enclosures, mechanism housings and structural hardware through a manufacturing network in eight countries. Its engineering team reviews gating and drawing callouts before tooling begins rather than after the first return.
The full guidance, including a tolerance cost comparison and FAQs, is available here.
About MES, Inc.
Headquartered in Lewis Center, Ohio, MES, Inc. is a global manufacturing sourcing and supply chain company serving OEMs in electrical and energy, automotive, robotics, lighting, and construction and agriculture. MES manages sourcing, engineering, quality and delivery across a global supplier network with operations in the United States, Mexico, Poland, India, Vietnam, China and beyond. MES has been ISO 9001:2015 certified since 2009 and is NMSDC certified. Learn more at https://mesinc.net.
SOURCE MES, Inc.

Share this article