PolyU Develops Novel Semiconductor Nanofiber with Superb Charge Conductivity

     (Photo: http://mma.prnewswire.com/media/489977/Nanofiber_Prof_Leung.jpg )

The innovation was awarded the Gold Medal with Congratulations of the Jury at the 45th International Exhibition of Inventions of Geneva, held on 29 March to 2 April this year.

Issues to Address 

Semiconductor made into nanofiber of diameter as small as 60nm (less than 1/1,000 of a human hair) have been widely used in modern daily life photonic devices (such as solar cells, photocatalyst for cleaning the environment), and non-photonic devices (such as chemical-biological sensor, lithium battery). However, electrons and holes generated by light or energy in semiconductor would readily recombine, thus reduce the current or device effectiveness. Such nature has limited the further development and applications of semiconductor nanofibers.

The novel technology developed by the research team led by Ir. Professor Wallace Leung, Chair Professor of Innovative Products and Technologies of the Department, have overcome such limitation. Applying electrospinning, the team succeeds in inserting highly conductive nano-structure (such as carbon nanotubes, graphene) into semiconductor nanofiber (such as Titanium Dioxide (TiO₂ ). The novel nano-composite so produced thus provides a dedicated super-highway for electron transport, eliminating the problem of electron-hole recombination.

Amidst the potentially wide applications of the innovation in many spectrum, Professor Leung's team has initially embarked on research of applying the novel nano-composite in two environmental aspects: solar cells, and photocatalysts for cleaning air.

Enhanced solar cell efficiency 

The latest generation of solar cells (e.g. dye sensitized solar cell (DSSC), perovskite solar cell) are promising clean and renewable energy sources. Yet, for more wide applications, there are still much room for further enhancing their power conversion efficiency and producing in more cost-efficient ways.

By applying PolyU's novel technology, carbon nanotube/graphene is embedded into the TiO₂ component of DSSC and perovskite solar cell, boosting an increase of energy conversion from 40-66%. Compared to commercially available multi-crystalline silicon solar cell common in the market, with current price at US$0.25 (HK$1.94)/kWh, the cost of DSSC with carbon nanotube embedded is 12-32% higher (HK$2.18 - 2.56); while perovskite solar cell embedded with graphene is 28-40% lower (HK$1.17 - 1.40).

Given the superb charge conductivity of the novel semiconductor nanofiber, there is great potential for prompt development of more efficient solar cells, and at lower cost, than the silicon cells.

Enhanced photocatalyst performance in cleaning the air 

TiO₂ is the most commonly used photocatalyst material in commercially available air-purifying or disinfection devices in the market. However, TiO₂ can only be activated by ultraviolet light (i.e. about 6% of solar energy), thus limiting its wider application as it is less effective in indoor environment. It is also relatively ineffective in converting nitric oxide (NO) into nitrogen dioxide (NO₂), at a rate of less than 5%.

By applying PolyU's novel technology, graphene roll is embedded into TZB composite (which mainly compose of TiO₂). The novel semiconductor nanofiber so produced has superb conductivity, which provides a graphene superhighway for electrons to transport more quickly to oxide the absorbed pollutants. The technology also significantly increases the novel nano-fiber's surface exposed for light absorption and trapping harmful molecules.

Such novel semiconductor nanofiber can convert about 90% of NO to NO₂, a 35% increase compared to composite without graphene. If compared to high-standard TiO₂ nano-particles commonly available in the market, the conversion rate is even 10 times more, yet 10 times more cost-efficient.

Readily available for wide applications 

Given the wide uses of semiconductor nanofiber now and in the future, the PolyU groundbreaking technology that develops semiconductor nanofiber with superb charge conductivity has great potential for further development for different applications.

Besides in solar cells and photocatalysts, other obvious examples of making use of such novel technology include the development of biological-chemical sensors with enhanced sensitivity and sensing speed, and lithium batteries with lower impedance and increased storage.

Media Contact:
Ir. Professor Wallace Leung
Chair Professor of Innovative Products and Technologies
Department of Mechanical Engineering
[email protected]

SOURCE The Hong Kong Polytechnic University (PolyU)